It s fairly easy to rectify though you just need to loosen the lower yokes and.
Motorcycle triple clamp alignment.
Doing this will free up the front end even more.
My handlebars were slightly out of whack after my bike went over last week.
On racing bikes the trail is usually adjusted with an adjustable triple clamp which changes the offset distance and can be adjusted in fine increments to fine tune the handling of the bike.
The first thing you should do is figure out if the handlebars themselves are bent before you start messing with the alignment.
You can not always trust the manufactures marks for the rear axel position 3.
The motorcycle wheels are straight and true.
The forks and triple clamp system is straight and true.
You use a tape measure from the swing arm pivot bolt to rear axel.
Support the front of the bike so that the bike will not slide up or down when you start working.
Aftermarket triple clamps can be purchased for road bikes to allow this adjustment and remove the need to change ride heights instead.
Tighten the lower triple clamp.
Changes in spring preload tires rear shock location or linkage or changes achieved by moving the forks up or down in the triple clamps all change the respective ride heights.
The steering stem is one piece with the lower clamp.
The height of the front of the motorcycle typically measured from one of the triple clamps and the height of the rear of the motorcycle.
So in addition to what you propose i would suggest you slack off the pinch bolt on the upper triple clamp securing it to the steering stem which holds the clamps in alignment or misalignment to allow it to rotate into alignment.
A quick simple method of aligning forks first time every time.